Start here · Essential guide
Concrete Mix Ratios: Cement, Sand, Ballast and Water Explained
Learn how concrete mix ratios work: cement, sand, ballast and water proportions, common ratios by job, grade-based mixes and tips for accurate batching.
Concrete Work
Cement, sand, aggregate and water proportions for footings, slabs, countertops and structural work, plus how to work out quantities.
Start here · Essential guide
Learn how concrete mix ratios work: cement, sand, ballast and water proportions, common ratios by job, grade-based mixes and tips for accurate batching.
Cement is the binder, concrete is cement plus sand and stone, and mortar is cement plus fine sand for bonding masonry. Compare the three and see which to use.
What to know about concrete countertop and worktop mixes: fine aggregate, low water content, reinforcement, thickness, curing and when to use a pre-bagged mix.
What M25, M30 and RC30 concrete grades mean, why higher grades need a mix design instead of a fixed ratio, and how Indian and UK grade names compare.
Which concrete mix to use for fence posts, garden footings and foundations, with ballast ratios, hole size guidance, quantity examples and mortar notes.
Typical cement, sand and aggregate ratios for reinforced roof slabs, columns, lintels and concrete steps, with worked quantities and notes on when to get an engineer.
One tonne of ballast typically needs about 6 to 8 bags of 25 kg cement at common 1:5 to 1:6 ratios. See how to convert volume ratios into weights.
A typical cubic metre of concrete needs roughly 300 to 400 kg of cement, depending on the mix. See the calculation, a ratio table and bag conversions.
How much water concrete needs, what the water-cement ratio means, how to judge consistency, why extra water weakens it and when wetting concrete helps.
Work out concrete volume for slabs, footings, posts and steps with simple formulas in metric and imperial, plus bag counts, waste allowance and worked examples.
A step-by-step guide to mixing concrete by hand in a wheelbarrow or on a board, with tools, safety, batch sizes, water control and common mistakes.
Neither is better everywhere: 20mm suits most slabs and footings, 10mm suits thin, congested or finish-critical work. See how to choose and what changes in the mix.
Type I is general-purpose Portland cement; Type II offers moderate sulfate resistance and lower heat. Learn the differences, Type I/II, and which to choose.
Related topics