Short answer
For concrete you mix yourself, a water-cement ratio of roughly 0.4 to 0.6 by weight is the typical range, with about 0.5 a common working figure. That is about 25 litres of water per 50 kg of cement. For bagged mixes, follow the quantity printed on the bag, and add the water gradually. Use as little as you can while still getting a workable, fully compacted mix.
What the water-cement ratio is
The water-cement ratio is the weight of water divided by the weight of cement in a batch. A ratio of 0.5 means that for every 1 kg of cement, there is 0.5 kg (0.5 litres) of water. It is the single biggest factor in the strength and durability of concrete.
Why more water weakens concrete
Cement needs only a portion of the mixing water to react chemically. The rest is there to make the concrete workable, and when it leaves, it leaves tiny pores. More water therefore means:
- lower strength;
- higher porosity and weaker resistance to frost and staining;
- more shrinkage, and a greater chance of cracking;
- a weaker, dustier surface.
A mix that looks wet and easy to place is rarely the strongest one.
How much water for a batch
Say you are using 50 kg of cement and a water-cement ratio of 0.5:
- Water = 50 × 0.5 = 25 litres.
The same logic works for any batch size. If you are using a ratio-based mix, you need to know how much cement is in the batch, which you can find from how much cement is needed for 1 cubic metre of concrete.
Bagged mixes
Bagged concrete mixes give a water quantity per bag, since the manufacturer has already set the cement content. For example, some 80 lb bags in the US call for roughly 3 quarts of water, but different products vary, so read the instructions. A common way to mix is to add about two-thirds to three-quarters of the water first, mix, and then add the rest in small amounts until the mix is uniform. Adding even an extra quart or so to a bag can noticeably reduce the finished strength.
Judging consistency
Most DIY mixes should look like thick porridge or oatmeal: wet enough that no dry pockets remain, but stiff enough to hold its shape and not slump into a puddle. Signs you have added too much:
- water pooling or shining on the surface;
- the mix running off the shovel;
- ridges that flatten out immediately.
If you have overshot, mix in a little extra dry material in the correct proportions, instead of leaving it sloppy. See how to mix concrete by hand without a mixer for the mixing steps.
Sand moisture
Sand and ballast often hold moisture, especially if stored outdoors or after rain. That water counts toward the total, so the amount you add should be reduced. If you do not account for it, a mix can end up with a high water-cement ratio without anyone adding “too much” from the hose.
Does wetting concrete make it stronger?
Not at mixing stage, but keeping the concrete damp after it is placed does help. Cement continues to react for weeks, and it needs moisture to do so. If the surface dries too quickly, it can be weak and crack. Good curing practice includes:
- covering fresh concrete with plastic sheeting or damp hessian;
- misting it lightly in warm or windy conditions;
- protecting it from frost.
That is different from adding more water to the mix, which does the opposite.
Plasticisers instead of water
If you want a more fluid mix without raising the water-cement ratio, a plasticiser (water-reducing admixture) is the correct tool, used per the manufacturer’s directions. It is better than relying on the washing-up liquid trick some tradespeople use. For the bigger picture on proportions, see our guide to concrete mix ratios.