Short answer
Type I is general-purpose Portland cement, used where no special properties are needed. Type II is Portland cement with moderate sulfate resistance and a moderate heat of hydration, which makes it suitable for concrete in contact with soil or groundwater that carries some sulfates. These designations come from the US standard ASTM C150.
Type I
Type I is the everyday choice for most building work: slabs, footings, walls, pavements and general masonry products. It has no special chemical or physical requirements beyond the standard.
Type II
Type II has a lower tricalcium aluminate (C₃A) content than Type I, which gives it better resistance to moderate sulfate attack and a slower, lower heat release as it hydrates. It is often used for:
- foundations and basement walls in contact with soil;
- retaining walls and drainage structures;
- larger pours where heat build-up is a concern.
Type I/II
Many manufacturers sell a single cement that meets both the Type I and Type II specifications and label it Type I/II. In North America this is widely available, which is why you may see bags of Type I/II in hardware stores. For most DIY projects, it is a sensible all-round choice.
The other types and Type IL
ASTM C150 also describes:
- Type III: high early strength, for fast-setting needs.
- Type IV: low heat of hydration, for massive pours.
- Type V: high sulfate resistance.
You may also see Type IL, a Portland-limestone cement under a different standard (ASTM C595), which has become more common. Its performance is intended to be comparable to Type I for general use, but check the product data for your application.
Which to use for DIY
For paths, patios, slabs and fence posts, a general-purpose cement (Type I or Type I/II) is normally fine. If your soil or groundwater is known to contain high sulfates, ask your supplier or a local engineer whether Type II or V is advisable. Bagged concrete mixes already contain cement, so you will not usually choose a cement type for them.
To see how cement fits into the finished product, read cement vs concrete vs mortar and our guide to mix ratios.
UK and EU: CEM I and “Type 1” confusion
In the UK and Europe, cement is classified under BS EN 197-1. CEM I is Portland cement with a very high proportion of clinker, and it is the closest equivalent to a general-purpose cement. CEM II types are composite cements that blend in other materials such as limestone.
Be aware that “Type 1” in UK builders’ merchants usually refers to MOT Type 1, a crushed-stone sub-base aggregate (see how deep the sub-base should be for a patio). It is not a cement at all, and mixing the two up is a common mistake.