Short answer
Cement is the fine grey powder that acts as the binder. Concrete is a mix of cement, water, sand and coarse aggregate (gravel or crushed stone), and it is used for structural elements. Mortar is a mix of cement, water and fine sand, usually with lime or a plasticiser, and it is used to bond bricks, blocks and stones. People often say “cement” when they mean concrete, which is where much of the confusion comes from.
Comparison table
| Cement | Concrete | Mortar | |
|---|---|---|---|
| What it is | Dry binding powder | Cement + water + sand + coarse aggregate | Cement + water + fine sand (+ lime or plasticiser) |
| Coarse stone? | No | Yes | No |
| Main purpose | Ingredient in the others | Slabs, footings, foundations, posts | Bedding and joining masonry |
| Strength | Not used alone | Generally higher | Generally lower, more flexible |
Cement
Cement is made by heating limestone and clay to form clinker, which is then ground into a powder. It sets and hardens when mixed with water, through a chemical reaction called hydration. Portland cement is the most common type. Cement is rarely used on its own, apart from in some slurries and grouts. See what Type I and Type II cement are for the main cement classifications.
Concrete
Concrete is the main structural material for slabs, footings, driveways, steps and posts. The coarse aggregate gives it bulk and strength. Typical hand-mixed ratios are around 1 : 2 : 4 (cement : sand : aggregate) or 1 : 5 to 1 : 6 cement to ballast, as set out in our guide to concrete mix ratios. Concrete reinforced with steel handles tension as well as compression.
Mortar
Mortar fills the joints between bricks, blocks and stones and bonds them together. It is usually weaker and more workable than concrete, which allows a wall to accommodate small movements without cracking. Typical mixes by volume include:
- UK: about 1 part cement to 4 to 6 parts building sand, often with a plasticiser, with the proportion depending on the exposure and the masonry units.
- US (ASTM C270 types): Type M is the strongest, Type S is strong and common for below-grade work, Type N is a general-purpose medium-strength mortar, and Type O is a softer type for interior or non-load-bearing work. A common proportion for Type N is 1 part cement, 1 part lime and 6 parts sand.
Premixed mortar and masonry cement are also widely sold. For proportions by job, see our mortar mix ratios for bricks and blocks, and for the US types, whether to use Type S or Type N mortar.
Grout and other terms
Grout is a thinner, more fluid mix used to fill cores in hollow concrete blocks or gaps under tiles and plates. Screed is a sand-and-cement layer used to create a flat finished floor. These are related to mortar, but have their own mixes.
Is mortar mix just sand and cement?
A plain sand-and-cement mix can work as mortar in some situations, but good mortar normally includes lime or a plasticiser, which improves workability and helps the mix cling to the masonry. Pre-bagged mortar mixes usually include these already.
Which one to buy
- Pouring a slab, footing or fence post base: concrete (or ballast and cement). See concrete mixes for footings, foundations and fence posts.
- Laying bricks or blocks, or repointing a brick wall: mortar.
- Mixing your own from scratch: buy cement plus the right aggregates.
Is it cheaper to buy cement or concrete? For large volumes, buying cement and aggregates separately is usually cheaper per cubic metre, but it takes more labour and measuring. For small jobs, bagged concrete mix is often more convenient and the price difference is small. For larger jobs, ready-mixed delivery avoids mixing altogether. To estimate how much you will need, see how to calculate how much concrete you need.