The short answer
Use Type N for most above-ground, non-structural brick, block or stone work, and for general repairs on standard residential walls. Use Type S where you need more strength, for example below grade, in retaining walls, in load-bearing walls and where wind or soil pressure is heavier.
Neither is “better” overall. A stronger mortar is not automatically the right choice, particularly with softer bricks.
Type S vs Type N at a glance
| Type N | Type S | |
|---|---|---|
| Typical minimum compressive strength (28 days) | About 750 psi | About 1,800 psi |
| Typical proportions (cement : lime : sand, by volume) | 1 : 1 : 6 | 1 : ½ : 4½ |
| Character | More workable, more flexible, smoother joints | Higher bond strength and weather resistance |
| Typical use | Above-grade exterior and interior walls, veneers, repointing | Load-bearing and below-grade work, retaining walls |
The strength figures and mixes are those commonly quoted from ASTM C270 and in manufacturers’ guides. Bagged products can vary, so check the label.
When Type N is the right choice
- Above-grade walls, inside or outside, that do not carry heavy loads.
- Brick and stone veneers.
- Typical garden walls and general repair work.
- Where the wall is built of softer bricks, and a more flexible mortar is a better match.
Type N is not usually recommended below grade or for retaining walls.
When Type S is the right choice
- Load-bearing walls and structural masonry.
- Foundations and other below-grade masonry.
- Retaining walls, where there is lateral pressure from soil.
- Walls in areas with high winds or seismic activity.
If you are unsure whether a wall counts as structural, check the plans or ask a local building official.
Watch out with soft or old bricks
A harder mortar is not always better. On softer or historic bricks, Type S can be stiffer than the brick, so the brick, rather than the joint, takes up the stress and can spall or crack. For repointing an old wall, a softer mortar is often the better choice; see how to repoint a brick wall.
What about Type N “cement”?
You will often see “Type N masonry cement” sold in bags, to which you add sand. It is a pre-blended product designed for general-purpose mortar. Always follow the bag’s mixing instructions, as the ratio of sand to cement differs by product. For general proportions and the other types (M, O, K), see our guide to mortar mix ratios.
Stone walls are covered separately in mortar ratios for stone masonry.
Quick decision guide
- Garden wall, above ground, ordinary bricks: Type N.
- Retaining wall, or any wall below ground: Type S.
- Load-bearing or structural wall: Type S, or whatever the plans specify.
- Old or soft brick: ask a specialist; a softer mortar is often recommended.
- Unsure: follow the plans, the product guide, or your local building rules.