What is a stone cladding wall?
Stone cladding is a thin layer of natural or manufactured stone fixed to the face of a wall. It is decorative and gives the look of a stone wall without building one. The wall behind it carries the structure, and the cladding is attached to it with adhesive, mechanical fixings or both.
Stone cladding materials
- Natural stone veneer. Thin pieces cut from real stone, such as slate, sandstone, limestone, quartzite or granite. Each has a distinct look and weight. Natural stone is heavier and often more expensive but weathers well.
- Manufactured (cast) stone. Moulded from cement and aggregates and coloured to resemble stone. Lighter than most natural stone and more uniform, but quality varies between products.
- Stone panels and mesh-backed strips. Pieces bonded to a backing for faster installation.
- Cement board as a backing. A cement board is a base layer onto which cladding or tile is fixed. It is useful when the wall is uneven or you want a consistent base.
Weight matters. Check the product’s weight per square metre against what the wall can carry, and follow the manufacturer’s guidance for heavier natural stone, which may need mechanical fixings.
What’s popular and what does it cost?
Sandstone, limestone and slate are common choices, and the most popular stone differs by region and style. Costs vary widely with the material, thickness, supplier and labour, and it is hard to give a reliable figure. Request quotes that separate materials from installation, and compare per square metre.
If you are looking for sandstone cladding at a particular retailer such as Bunnings, stock varies by store and over time, so check their current range directly.
Is your brick wall suitable?
Sound, clean brickwork is generally a good substrate. Before you start:
- check for crumbling bricks or mortar, bulging or large cracks, and repair them;
- look for damp, and fix the cause first;
- remove paint, flaking coatings and dust, since adhesive needs a sound surface. See why mortar won’t stick to brick for common bond problems;
- confirm the wall can carry the extra weight.
You can screw into brick using masonry anchors or screws drilled into a pilot hole, but screw into the brick body where possible and not into crumbling mortar.
Fixing cement board to brick
A common method, as described in a Google AI Overview for this topic and widely repeated by installers, is:
- Prepare the brick. Clean off dust and debris and repair crumbling mortar.
- Cut the boards. Score and snap cement board, leaving small gaps at the edges and staggering joints.
- Apply adhesive. Spread thinset mortar with a notched trowel, or use a suitable construction adhesive, to help level small surface variations.
- Fix mechanically. Drill into the brick and fasten with masonry anchors or concrete screws, keeping heads flush and a little away from board edges to avoid cracking.
- Treat the joints. Use alkali-resistant mesh tape embedded in thinset.
For an outdoor wall, follow the board manufacturer’s instructions on moisture protection, and fix an exterior-rated product. Indoors, tile or stone can then be bonded to the board.
Fixing stone veneer
For lightweight manufactured stone, a common method is to apply a scratch coat of mortar to a clean, prepared surface or lath and then set the stone with mortar. See rendering and plastering walls for how scratch coats work. Natural stone should be fixed according to the supplier’s advice.
Finish with attention to water management: flashings at the top, drainage at the base, and sealed joints near windows and doors, so water does not get trapped behind the cladding.