Render, Screed and Finishes

Why won't mortar stick to my brick?

Mortar that won't stick to brick is usually down to dirt, paint, brick suction, a poor mix or weather. Learn the common causes and how to fix each one.

On this page
  1. The short answer
  2. Common causes
  3. Fixes to try
  4. How long should you wait before pointing?

The short answer

Mortar usually fails to stick to brick because of the surface (dust, dirt, paint, efflorescence or a very smooth, dense face), the brick’s water absorption (too dry or too wet), a mix that is wrong for the job, or poor weather and timing. Cleaning the brick, adjusting its dampness, fixing the mix and working in suitable conditions solves most cases.

Common causes

A dirty or sealed surface

Dust, soot, grease, algae, loose old mortar, paint and sealers all act as a barrier between the brick and the mortar. Brush the brick thoroughly, remove loose material, and clean off grease or algae. Paint and coatings usually need to be removed from the area being repaired.

Brick suction: too dry or too wet

Brick absorbs water. If the brick is very dry and absorbent, it can pull water out of the mortar before the cement has had a chance to bond. A common remedy is to dampen the brick lightly beforehand, so it is damp but with no standing water. If the brick is saturated, such as after rain, or it is very dense with low absorption, the mortar can slide off, and you may need to let it dry or use a bonding agent.

A mix that’s too wet, too dry or too weak

  • Too much water makes the mortar slump and weakens the bond.
  • Too little makes it hard to work and press into the surface.
  • A mix with too little cement, or sand that is dirty or the wrong type, may have weak adhesion.
  • Mortar that has begun to stiffen should not be revived with lots of water. Mix a fresh batch instead.

If you are mixing from scratch, our guide to rendering and plastering walls: mix ratios, application and curing explains the usual proportions and sand choice.

Weather and curing

Mortar applied in very hot, windy or sunny conditions can dry before it bonds. Frost damages fresh mortar, and heavy rain can wash it out. Protect fresh work and keep it damp, but not wet, while it cures.

Application

Mortar needs to be pressed firmly into the surface so it fills the pores and joints without air pockets. Overworking or retrowelling after it has started to stiffen can break the bond.

Fixes to try

  1. Clean the surface and remove loose or painted areas.
  2. Roughen smooth faces slightly where appropriate.
  3. Lightly dampen absorbent brick, and let any excess water soak in.
  4. For dense or smooth surfaces, consider a suitable bonding agent or primer, following the manufacturer’s instructions.
  5. Mix a fresh, correctly proportioned batch with clean sand.
  6. Press the mortar in firmly and protect it from sun, wind, rain and frost.

If the surface has been painted and you plan to coat it, see whether you can render over painted brick.

How long should you wait before pointing?

Pointing (finishing the joints) is usually done when the mortar has stiffened enough to hold a firm thumb impression but is not yet fully hard. That may be a few hours to a day depending on the weather and mortar. Pointing too early smears the face, and too late makes the mortar hard to work.

The complete guide to render, screed and finishes

Rendering and Plastering Walls: Mix Ratios, Application and Curing
Read the guide

Keep exploring

Guides from other topics

All topics →