Render, Screed and Finishes

Self-Levelling Compound vs Sand and Cement Screed: Which Do You Need?

Self-levelling compound suits thin, smoothing jobs; sand and cement screed suits deeper build-ups, falls and heavy duty floors. Compare depth, prep, drying and skill.

On this page
  1. The short answer
  2. What each one is
  3. Depth and falls
  4. Substrate and preparation
  5. Drying and speed
  6. Cost and skill
  7. Which to choose

The short answer

Use a self-levelling compound for thin layers on a floor that is already fairly flat and sound, typically to smooth it before tiles, vinyl or carpet. Use a sand and cement screed when you need to build up depth, create falls, or lay a new base over a slab or insulation. Self-levelling compounds have maximum depths set by the manufacturer, and that is usually the deciding factor.

What each one is

  • Sand and cement screed is a fine mix of cement and sharp sand with no coarse stone. It is laid to give a flat, level layer on a concrete slab or insulation, and it is where underfloor heating pipes are often covered. It is typically laid by hand and finished with floats and straight edges.
  • Self-levelling compound is a ready-mixed powder that you mix with water to a runny consistency and pour. It finds its own level and gives a smooth surface. Many are polymer-modified and are designed for thin layers.

A construction guide that compares screed and concrete describes screed as the layer that gives a flat surface ready for floor coverings, and notes that most slabs aren’t flat enough to finish directly. The same logic applies when choosing between these two levelling methods.

Depth and falls

  • Thin layers (a few millimetres up to what the product allows): self-levelling compound is often easier. Some products can be laid thicker, but the product data sheet sets the limit.
  • Thicker build-ups: sand and cement screed is the usual choice, and some self-levelling products are not suitable at depth or need aggregate added. See how thick a sand and cement screed should be.
  • Falls and slopes: a self-levelling product finds a level surface, so it won’t create a fall. A screed can be laid to a slope, for example in a wet room.

Substrate and preparation

A self-levelling compound needs a sound, clean, dust-free base, usually with a primer, and sealed gaps so it doesn’t leak. It will not hide movement cracks or loose areas. A sand and cement screed can bridge a rougher base, but it still needs a sound slab and, depending on the design, a bond coat or a membrane.

Drying and speed

Self-levelling compounds are often quick to walk on and many are ready for coverings sooner than a thick sand and cement screed. A traditional screed is slower, and thicker layers take longer. Check the data sheet for the product, and see how long sand and cement screed takes to dry.

Cost and skill

Self-levelling compounds are easy to use in small rooms but cost more per square metre for material, especially at depth, and they set quickly, so you need to be organised. Sand and cement screed is cheaper by material but needs skill to compact and finish flat. For home DIY on a small area, a compound is often more forgiving; for a whole floor, many people hire a screeder.

Which to choose

Situation Likely choice
Slab is nearly flat, you need a smooth base for flooring Self-levelling compound
New floor build-up over slab or insulation Sand and cement screed
Deep hollows or large depth variation Sand and cement screed (or screed first, then compound)
Need a fall to a drain Sand and cement screed
Floor must be ready quickly Check fast-drying products and the data sheet

You can also combine them: screed to bring the floor to level, then a thin skim of compound for a perfect finish. For the screed mix itself, see sand and cement floor screed mix ratios.

The complete guide to render, screed and finishes

Rendering and Plastering Walls: Mix Ratios, Application and Curing
Read the guide

Keep exploring

Guides from other topics

All topics →