Concrete Repair

Cracks in Concrete Slabs and Foundations: What's Acceptable and How to Fix Them

Most hairline cracks in concrete slabs are normal. Learn which cracks are acceptable, which ones need attention, and how to repair and monitor them.

On this page
  1. Short answer: most hairline cracks are normal
  2. Why concrete cracks
  3. Which cracks are usually acceptable
  4. Cracks you should not ignore
  5. How to monitor a crack
  6. How to repair a cracked slab
  7. Should hairline cracks be repaired?
  8. What happens if a house has a cracked foundation?
  9. Slab lifespan and concrete strength
  10. When to call a professional

Short answer: most hairline cracks are normal

Almost every concrete slab cracks at some point. Concrete shrinks as it dries, and a slab that is restrained by the ground, footings or walls can’t shrink freely, so it relieves the stress by cracking. Fine, tight cracks that don’t change over time are usually cosmetic.

The cracks worth worrying about are the ones that are wide, getting wider, offset (one side higher than the other), or accompanied by other signs such as sticking doors or cracks in the walls above. This guide helps you sort cracks into “leave it”, “monitor it”, “repair it” and “get a professional”.

Why concrete cracks

Common causes include:

  • Drying shrinkage. Water in the mix that isn’t needed for hydration evaporates, and the concrete shrinks slightly. This is the most common cause of fine cracks in the first months.
  • Temperature changes. Concrete expands and contracts with temperature. Joints are cut or formed in slabs to give the cracking somewhere to go.
  • Settlement. If the ground under a slab was poorly compacted, or washes out over time, the slab can drop or tilt. See how to fix a sunken concrete slab.
  • Reactive or moving soil. Clay soils swell when wet and shrink when dry, which can lift and drop parts of a slab or footing.
  • Overloading or poor construction. A slab that is too thin, has weak concrete, or wasn’t cured properly is more likely to crack.
  • Corroding reinforcement. Rusting steel expands and can crack and spall the concrete over it. See repairing spalling concrete.

Which cracks are usually acceptable

Fine cracks that are stable, roughly straight or randomly patterned, and show no height difference across them are generally considered normal in slabs and are often left alone or sealed for appearance and to keep water out.

How wide is too wide?

There is no single number that applies everywhere. Building codes, Australian Standards, builders’ warranty guidelines and engineering guidance each treat crack width differently, and the limit depends on what the concrete is doing (a floor slab inside a house, a driveway, a retaining or water-holding structure). As a rough practical guide, many people treat cracks you can barely get a fingernail into as minor, and cracks that you can fit a coin or pencil into as ones to get assessed. If a crack is wider than a few millimetres, is growing, or is in a structural element such as a footing or beam, ask a qualified professional to look at it rather than relying on a rule of thumb.

A note on Australian homes

Searches about acceptable cracks in slabs in Australia usually relate to new builds. Slabs on reactive soils are designed to be a bit flexible and some cracking is expected. If you have a new home and are worried about a crack, check your builder’s contract and warranty documents, which often include tolerances, and consider an independent engineer’s or building inspector’s report. Don’t quote a generic width figure to a builder as if it were a legal limit; the applicable standard and the contract govern.

Cracks you should not ignore

Get a qualified person (a structural engineer or experienced building inspector) to look at a crack if:

  • It is growing, or you can see it has changed over weeks or months.
  • One side is higher than the other (vertical displacement).
  • It is wide enough to fit a coin or more.
  • It runs through a footing, beam, or foundation wall rather than just a floor surface.
  • There are matching cracks in brickwork or plasterboard above, especially diagonal cracks near door and window corners.
  • Doors and windows are sticking or no longer close properly.
  • Water is leaking through it, or there are signs of rusting steel.
  • It appeared suddenly after flooding, heavy rain, a nearby excavation or a tree being removed.

How to monitor a crack

If you aren’t sure, monitor it. Mark each end of the crack with a pencil line and date it, then measure the width at a fixed spot with a crack gauge or a ruler, and photograph it with a coin or scale for reference. Check again after a few weeks and after seasonal changes. A crack that doesn’t move is much less worrying than one that does. Bring your records if you later call a professional.

How to repair a cracked slab

Yes, a cracked slab can usually be repaired, though repair addresses the symptom. If the ground or structure is still moving, a repair may crack again.

Hairline and shrinkage cracks

For stable cracks, clean out dust and debris, then fill with a suitable flexible crack sealant or a cement-based or polymer crack filler. Sealing keeps water and dirt out. If the crack is in a visible slab and you want it to blend in, choose a filler designed for concrete and follow the maker’s directions. For help choosing, see what to patch concrete with.

Wider cracks

For cracks that are wider but stable, common options include:

  • Routing and sealing: widening the crack slightly into a neat groove and filling with flexible sealant, which suits cracks that move a little with temperature.
  • Epoxy injection: a rigid structural bond, suitable for cracks that have stopped moving. Professionals commonly do this.
  • Polyurethane injection: more flexible, often used for leaking cracks.

Rigid fillers in a crack that keeps moving will usually just crack again next to the repair.

Vertical displacement

When one side of a crack has dropped, the cause is usually ground movement or poor support, and the fix is to deal with that cause. Options include raising the slab by injection or replacing it. See fixing a sunken concrete slab and whether it’s cheaper to replace or repair.

Should hairline cracks be repaired?

Often they don’t need structural repair. Sealing them is still reasonable where water can get in, particularly outdoors in freezing climates, where trapped water can make the crack grow, or where the slab will be covered with flooring or a coating that could show or telegraph the crack. Inside a dry house, a hairline crack that is stable can be left.

What happens if a house has a cracked foundation?

It depends on the crack. Minor cracks in a foundation wall or slab are common and often only let in a little moisture. More serious cracks can allow water entry, indicate movement of the structure, and in the worst cases affect how loads are carried. Because the outcomes range from cosmetic to serious, treat a foundation crack as a reason to get it assessed if it meets any of the warning signs above. Foundation repairs and any structural assessments should be done by qualified professionals.

Slab lifespan and concrete strength

A well-built slab-on-ground foundation can last for many decades, and there’s no fixed expiry date. How long it lasts depends on soil conditions, drainage, concrete quality and maintenance. Keeping water draining away from the slab and avoiding leaks near it helps.

On concrete strength, a 25 MPa concrete has a higher specified compressive strength than a 20 MPa concrete. The grade needed depends on the application and the local standard or engineer’s design, so use whatever your plans or engineer specify. Testing (for example, slump tests and cylinder or cube strength tests) is typically done by the supplier or contractor on larger or engineered pours; ask your builder or engineer what testing applies to your project.

When to call a professional

Call a structural engineer or experienced foundation specialist for any crack that meets the “do not ignore” list, and for any crack in a footing, beam or retaining structure. For cosmetic slab cracks, a DIY filler is reasonable. If you also have cracked block or brick walls, see shrinkage cracks in concrete block walls. For a garage slab with widespread damage, see repairing or replacing a damaged garage floor. For cracked render on a wall, see how to repair cracks in render.

Keep exploring

Guides from other topics

All topics →