Why render cracks
Cracks in render have several common causes:
- A mix that is too strong or too rich in cement, which shrinks more as it dries.
- Drying too fast, because of hot sun, wind or no curing.
- Coats that are too thick or applied without letting the previous coat firm up.
- Movement in the building, such as thermal movement or settlement.
- Water getting behind the render, then freezing or causing damp.
- No movement joints on long runs or where different materials meet.
Knowing the cause matters because repairing a crack without addressing it often means it comes back. For the preventive side, see rendering and plastering walls.
Hairline cracks vs serious cracks
- Hairline or craze cracks (very fine, often a network pattern) are usually shrinkage and often cosmetic. They can still let water in over time.
- Wider cracks, stepped cracks following mortar joints, or cracks that keep growing may point to movement in the structure. If you can see a crack that is getting bigger, is wide enough to slip a coin into, or comes with sticking doors or windows, get a surveyor or structural engineer to look at it before cosmetic repairs.
Check whether the render is loose
Tap the surface around the crack with the handle of a trowel or your knuckles. A hollow sound suggests the render has come away from the wall. Loose areas need to be cut back to a sound edge and re-rendered, since filling a crack over a hollow area will not hold.
Repairing hairline cracks
- Brush out dust and loose material and wash off algae.
- Apply a flexible exterior filler or a masonry crack-bridging paint or sealer made for fine cracks, following the label.
- Let it dry and then repaint with a masonry paint. Textured masonry paints can help hide and bridge fine cracks. See best paint for roughcast walls and concrete.
Repairing wider cracks
- Use a tool such as a plugging chisel or the corner of a scraper to open the crack slightly into a V shape, which gives the filler something to grip. Wear eye protection.
- Brush out dust, then dampen the edges lightly.
- Fill with a repair mortar or a suitable exterior filler, pressing it in firmly in layers if the crack is deep.
- Smooth it level with the surrounding texture, and match the finish as well as you can.
- Cure by keeping it shaded and lightly damp for a few days for cement-based repairs.
- Paint the whole wall if the colour will not match, since patches often show.
Larger patches
For hollow or blown areas, cut back to firm render in a neat shape, remove loose material, and dampen. Apply a scratch coat, allow it to firm up, then add the top coat. If the mortar does not grip the wall, see why mortar won’t stick to brick.
Stopping cracks returning
- Use a suitable mix that is no stronger than needed, and avoid over-rich top coats.
- Apply in coats, not one thick layer.
- Keep new render damp and protected for several days so it cures slowly.
- Avoid rendering in hot, windy or freezing weather.
- Include movement joints where the design or the manufacturer calls for them.
- Fix leaks and keep gutters working so water does not soak the wall.