The short answer
A sand and cement screed can usually be walked on lightly after about 24 to 48 hours, but it takes much longer to dry enough for a floor covering. A widely used rule of thumb is about one day per millimetre of thickness for the first 50 mm, with thicker screeds taking longer for each extra millimetre. A typical 50 mm screed therefore needs roughly seven weeks in good conditions, and a 75 mm screed may need considerably more. These are guides, not guarantees.
Walk-on time vs ready-for-flooring time
There are two separate milestones:
- Walkable. The screed has hardened enough to take light foot traffic, typically within a day or two. Heavy loads, such as stacked plasterboard, should wait longer.
- Dry enough for coverings. Moisture in the screed has fallen to a level the floor covering can tolerate. This is the one that takes weeks.
Laying tiles, timber, vinyl or carpet on screed that is still damp can lead to adhesive failure, lifting, mould or warped boards.
What changes the drying time
- Thickness. The thicker the screed, the longer it takes.
- Mix. A wetter mix has more water to lose.
- Temperature and humidity. Warm, well-ventilated rooms dry faster. Cold, damp or closed-up spaces slow it.
- Airflow. Open windows or use a dehumidifier in suitable conditions.
- Floor build-up. A screed over a damp-proof membrane can only dry upward.
- Screed type. Liquid (flowing) screeds, fast-drying screeds and additive-modified screeds have different drying times, so use the manufacturer’s figure for those.
Testing whether it is dry
Do not rely on how it looks. Screed can look dry on top and still hold moisture. Common checks include a hygrometer test, where a sensor is sealed to the surface and the relative humidity is read, or a calcium carbide meter test done by a professional. Many floor covering suppliers specify a maximum moisture level, and for timber it is generally lower than for tiles. Check the instructions for your floor.
A simple taped plastic sheet test, where a square of polythene is taped down for a day or two and checked for condensation, can hint at wet screed, but it is not a substitute for a proper test.
Speeding it up safely
- Keep the room ventilated and, if it is humid, use a dehumidifier.
- Don’t turn on heating too early or too hot. Forced drying too soon can cause cracking and curling. Check the guidance for underfloor heating.
- Let the screed cure first. In the first days, protect it from drying too fast. See sand and cement floor screed mix ratios for mixing and curing basics.
If you are in a hurry, a thin self-levelling compound or a fast-drying screed may suit better. Compare them in self-levelling compound vs sand and cement screed, and check the depth you need in how thick a sand and cement screed should be.