Bricklaying and Mortar

How Thick Should Mortar Joints Be Between Bricks?

Standard mortar joint thickness for brickwork is about 10 mm (3/8 inch). Learn why it matters, how to keep courses consistent and what goes wrong.

On this page
  1. The short answer
  2. Why 10 mm is standard
  3. Course gauge: keep courses consistent
  4. What happens if joints are too thick
  5. What happens if joints are too thin
  6. Joint finishes
  7. Tips for consistent joints

The short answer

The usual mortar joint thickness between bricks is about 10 mm (roughly 3/8 inch). Bed joints (horizontal) and perpends (vertical) should look the same width. Small variations, for example 8 to 12 mm, are normal in hand-laid work, but you should aim to keep joints consistent across the wall.

Some specifications allow a slightly different thickness, and thin-bed systems used with certain blocks use joints of only a few millimetres, so check the project specification or product guidance.

Why 10 mm is standard

  • Brick sizes are designed around it. A UK standard brick is 215 × 102.5 × 65 mm. Add a 10 mm joint and each course is 75 mm tall and each brick takes up 225 mm along the wall, which makes the maths simple.
  • It is strong and forgiving. A joint of this thickness fills the irregularities in the bricks and gives a full bond without excess mortar.
  • It looks right. Even joints give a neat appearance.

Course gauge: keep courses consistent

With a 65 mm brick and 10 mm joint, four courses measure 300 mm. Bricklayers use a gauge rod (a batten marked with course heights) to check each course matches the plan, so the wall rises evenly and ties in with window sills, lintels and damp-proof courses. In the US, the equivalent course heights depend on brick size, and a modular brick with a 3/8 inch joint is designed to give an 8 inch (200 mm) height for three courses.

To set up the first course so everything above it stays level, see how to lay the first course of bricks.

What happens if joints are too thick

  • The wall becomes weaker and more prone to settlement and cracking as the mortar compresses and shrinks.
  • Courses may squeeze or slump, particularly with a wet mix.
  • The face may look uneven and use more mortar than necessary.

What happens if joints are too thin

  • Bricks can sit unevenly on high spots, and the mortar may not fully fill the bed.
  • Poor bond between the bricks and the mortar.
  • Little tolerance for irregular bricks.

Joint finishes

How the joint is shaped (tooled) affects how well it sheds water:

  • Concave (bucket handle): a popular, durable, weatherproof profile.
  • Weathered or struck: sheds water well when done properly.
  • Flush: simple but gives less protection from rain.
  • Recessed or raked: can look attractive but can hold water, so it is less suitable in exposed places or with soft bricks.

Tool the joints once the mortar is thumbprint firm; see mortar consistency.

Tips for consistent joints

  • Use a gauge rod and a line to set the height of each course.
  • Use a bed of mortar that is about the right thickness before pressing the brick down. A well-mixed, workable mortar compresses to the right thickness; see mortar mix ratios.
  • Keep the perpends the same width as the bed joints, filled completely.
  • Check level and line every few bricks.
  • If you are repointing, match the existing joint widths and profile; see how to repoint a brick wall.

The complete guide to bricklaying and mortar

Mortar Mix Ratios for Bricks and Blocks
Read the guide

Keep exploring

Guides from other topics

All topics →