The short answer
A single skin brick wall (one brick wide, 102.5 mm thick in the UK) is slender, and it depends on piers (thickened sections) and good foundations to stay upright against wind. The usual approach is to keep it low and to put piers at regular intervals. A figure sometimes seen for pier spacing is roughly every 1.8 to 3 metres, but this varies with wall height and wind exposure.
There is no single safe maximum height that applies everywhere. Safe height depends on exposure to wind, wall thickness, pier size, and the mortar and bricks. For anything other than a low garden wall, get advice from your building control office, a structural engineer or the brick manufacturer’s design guidance.
What “single skin” means
A single skin wall is one leaf of brickwork laid in stretcher bond, one half-brick thick. In the UK that is 102.5 mm. It is common for low garden walls and for the inner and outer leaves of cavity walls. As a freestanding wall, it has little resistance to sideways wind pressure compared with a thicker wall; see types of brick bond for the alternatives.
Why piers are needed
Wind pushes a freestanding wall sideways. A thin straight wall can resist this only up to a modest height. Piers act like buttresses: a thicker column of brickwork, bonded into the wall, that stiffens it and limits how far the panel between them can span.
Without piers, or without thickening the wall, the wall may crack or even overturn, particularly with a heavy cap or in an exposed position.
Pier spacing and size
As rules of thumb used in domestic work:
- Spacing: piers are typically placed at regular intervals, commonly in the range of about 1.8 to 3 metres between centres. Closer spacing allows a higher or more exposed wall.
- Size: a pier is usually at least one brick square (215 × 215 mm, projecting from the wall), often larger for taller walls.
- Bonding: piers should be bonded into the wall by alternating bricks course by course, not just butted up against it.
- Ends: put a pier at each end and at corners.
Treat these figures as starting points only. The correct spacing is a design decision, and wind exposure in your area matters a great deal.
Height limits
Higher walls, exposed sites, solid caps and gates all raise the loads. Typical guidance is that:
- A half-brick wall is only suitable for low walls, and the height should be modest compared with its length between piers.
- Increasing the thickness (to a one-brick wall) or the size of the piers allows more height.
- Planning rules limit the height of boundary walls in many places, so check with your local authority as well as for structural safety.
Rather than quote a single number, the safest advice is to check a recognised design guide (such as the UK guidance for freestanding walls) or ask a professional.
Footings
A freestanding wall needs a proper concrete footing. See how deep a footing should be for a brick wall for depths, widths and ground conditions. Poor footings are among the most common causes of cracked and leaning garden walls.
Mortar, joints and movement
- Use a mortar suited to exposed freestanding work; see mortar mix ratios.
- A common joint width is about 10 mm; see how thick mortar joints should be.
- Include a damp-proof course below the lowest brick courses where required, and a coping or capping to keep rain out of the top of the wall.
- Long walls need movement joints at intervals; clay brick walls expand and contract, so check the manufacturer’s recommended spacing.
How thick is a 1.5 brick wall?
A one-and-a-half brick wall is built from a brick length plus a half-brick width, with a joint between. In the UK, that is about 327.5 mm (215 + 10 + 102.5 mm). The table shows common UK thicknesses (for the brick dimensions themselves, see standard brick sizes):
| Wall | Approximate thickness |
|---|---|
| Half brick (single skin) | 102.5 mm |
| One brick | 215 mm |
| One and a half bricks | 327.5 mm |
When to get advice
Ask a structural engineer or your local building control team if the wall is taller than a low garden wall, is in a very exposed site, sits next to a public footpath or road, retains soil, or will carry gates or heavy decoration. A wall that falls can cause serious injury, so this is not a place for guesswork.