The short answer
There is no single depth that is right everywhere. The footing for a brick wall has to reach firm, undisturbed ground, and be deep enough to avoid frost heave and seasonal soil movement. For a low garden wall in ordinary soil, builders often dig a trench in the region of 450 to 600 mm deep in the UK, with a layer of concrete at the bottom, but this is a rule of thumb and not a code requirement. In cold climates, such as much of the northern US and Canada, footings commonly need to extend below the local frost line, which can be much deeper.
Always check local building rules or ask a professional, particularly for tall, retaining or boundary walls.
What decides the depth
- Frost depth: in places where the ground freezes, water in the soil expands and can lift a shallow footing. Footings are normally taken below the frost line, and your local building department can tell you the depth.
- Soil type: firm ground (dense gravel, compact sand, stiff clay) supports more than loose or soft ground. Topsoil and made-up ground are not suitable to bear a footing and must be dug through.
- Clay soils and trees: clay shrinks and swells with moisture, especially near trees and hedges, and deeper foundations are often needed there. Ask for local advice.
- Wall height and thickness: taller and heavier walls need wider, deeper footings. A half-brick wall also needs piers; see single skin wall pier spacing.
- Slopes and drainage: a footing on a slope may need to be stepped, and poor drainage can undermine it.
Typical dimensions for a garden wall
These are commonly used starting points for a low garden wall in good ground. They are not a design:
- Concrete thickness: often at least 150 mm, or at least as thick as the wall is wide.
- Footing width: commonly about two to three times the wall thickness, centred under the wall.
- Trench depth: deep enough for the concrete plus a few brick courses below ground level, with the top of the footing set below the soil surface so the lowest courses are buried.
A simplified method of sizing a footing is to divide the load by the soil’s allowable bearing capacity, which gives the area needed. This is only a first estimate, and real design may involve more loads and reinforcement, so a professional should check complicated projects.
Steps for a typical garden wall footing
- Mark out the wall line and dig the trench to the required depth and width, to firm ground.
- Remove loose soil, roots and organic material and level the base.
- Place pegs at the finished level of the concrete so the top is level.
- Pour the concrete (see concrete mixes for footings) and compact it, working it into the corners.
- Level the surface and leave it to set; see how soon you can lay bricks on new concrete.
- Start the first course; see how to lay the first course of bricks.
When to get advice
Get a professional opinion or check with your building control office if:
- The wall is taller than a low garden wall.
- It retains soil or is next to a road or footpath (see whether a 2 foot retaining wall needs a footing).
- The soil is soft, made-up or clay near trees.
- You are in a cold climate and unsure of the local frost depth.
- The wall will carry a roof or other loads.
A footing that is too shallow or too narrow is hard to correct once the wall has been built, so it is worth checking first.