Retaining Walls

Does a 2 foot retaining wall need a footing?

A 2 foot retaining wall may need a concrete footing or just a compacted gravel base, depending on the wall type. See what each type typically requires.

On this page
  1. Short answer
  2. By wall type
  3. What a compacted base looks like
  4. When a concrete footing is needed
  5. Frost depth and soil
  6. Burying the first course

Short answer

It depends on the type of wall. A low dry-stacked wall made from segmental retaining blocks usually sits on a compacted crushed-stone base, not a poured concrete footing. A mortared brick or block wall, or a poured concrete wall, normally needs a concrete footing even at 2 feet. Either way, a wall needs some prepared foundation: firm ground, a level base and, in cold climates, attention to frost.

By wall type

Wall type at about 2 ft Typical foundation
Segmental (dry-stack) concrete blocks Compacted crushed stone base, commonly around 6 inches thick, with the first course partly buried. Many manufacturers do not require concrete. See block walls
Mortared hollow block Concrete footing, usually reinforced with dowels into the wall
Brick Concrete footing; see brick walls
Poured concrete Concrete footing, often poured first; see formwork
Dry stone Firm, level base, often with larger stones at the foot; see dry stone walls
Gabion Level, compacted base; see gabion walls
Concrete sleeper Footings for the posts; see sleeper walls

Always check the manufacturer’s instructions for the specific product, which override general rules of thumb.

What a compacted base looks like

  1. Remove topsoil and soft material and dig to firm ground.
  2. Add crushed stone (angular, with fines, so it compacts) in layers.
  3. Compact each layer with a plate compactor or hand tamper.
  4. Check level along the length and across the width.

A good base matters because every course above it follows the level of the first. A rushed or uneven base is one of the most common reasons for a wavy or settling wall.

When a concrete footing is needed

A concrete footing is generally the right choice if:

  • the wall is mortared (brick or block);
  • the wall is poured concrete;
  • soil is weak, soft or variable;
  • the wall supports a slope, driveway or structure, or sits close to a boundary;
  • the wall has posts, such as a sleeper wall;
  • local rules or the design require it.

Typical footings are wider than the wall and a few inches to a foot or more thick, sized by the designer. Quantities are worked out in the DIY retaining wall planning guide.

Frost depth and soil

In cold climates, wet soil freezes and expands. A footing or base that sits above the frost line can heave. Rigid footings are normally taken below local frost depth, which varies from a few inches in mild regions to several feet in cold ones. Local building departments publish the figure. Some segmental walls on well-drained gravel bases tolerate frost because the base drains; again, follow the product’s instructions.

Clay and organic soils are poor bases. If you find soft ground, dig it out and replace it with compacted stone.

Burying the first course

Besides the base, most walls need the bottom of the face buried. A commonly quoted rule is to bury about one third of the height, but segmental block manufacturers specify smaller amounts; see the 1/3 rule for retaining walls. For a 2 foot wall, that typically means burying the first course or a few inches.

Finally, even a low wall needs drainage; see drainage for a 600mm (2 ft) wall.

The complete guide to retaining walls

How to Build a Retaining Wall Yourself: Materials and Planning
Read the guide

Keep exploring

Guides from other topics

All topics →