Short answer
Usually yes, in some form. A wall 600mm (about 2 feet) high is a low wall, and the water pressure on it is modest, but water trapped behind any retaining wall adds load and can cause staining, frost damage, leaning or bulging over time. Because drainage is cheap to include when building and difficult to add afterwards, it is a sensible default even at this height. The amount of drainage you need depends on the wall type and soil.
Why height doesn’t remove the need
Soil that is wet is heavier and pushes harder than dry soil, and standing water pushes in addition. A low wall deals with less of both, but a few things still apply:
- Water that cannot get out will keep the soil behind the wall saturated.
- In cold climates, freezing water expands and can push a wall or lift its base.
- On clay soil, which drains poorly, water builds up behind even a short wall.
- Rain runoff from a slope above the wall, or from paving or a roof, can concentrate behind it.
When drainage matters most
Give extra attention to drainage if:
- the soil behind the wall is clay or heavy;
- the ground above slopes toward the wall;
- the wall is solid, such as mortared brick or poured concrete, so water can’t pass through;
- you live where freezing is common;
- downpipes or paved areas drain towards the wall.
What a 600mm wall needs, by type
| Wall type | Typical drainage approach |
|---|---|
| Dry-stacked segmental blocks | Clean angular gravel directly behind the blocks, plus a perforated pipe at the base for most walls. Water can also drain through the joints. See block walls |
| Dry stone | Water passes through the joints; use free-draining backfill. See dry stone walls |
| Gabion | Permeable by nature; filter fabric stops soil washing out. See gabion walls |
| Mortared brick or block | Weep holes through the base course, plus gravel behind. See brick walls |
| Concrete sleeper | Gravel behind sleepers, a base drain, and fabric on the back. See sleeper walls |
| Poured concrete | Weep holes or a drain pipe at the base, with gravel behind. See formwork |
A simple drainage build
- Make the base slightly sloped so water moves to an outlet.
- Lay a perforated drain pipe at the base, holes down or as the manufacturer recommends, falling gently to a point where water can leave, such as the end of the wall, a soakaway or a lower area of the garden.
- Surround it with clean angular stone, not sand or soil.
- Place a layer of the same stone behind the wall, commonly at least about 12 inches (300mm) wide for low walls, and wrap it with non-woven filter fabric so soil does not clog it.
- Backfill the rest with suitable granular soil in thin, compacted layers, and finish the top surface so rain runs away from the wall rather than into it.
More detail on materials is in what to backfill behind a retaining wall.
Signs of drainage trouble
- Wet patches or staining on the face.
- White powdery deposits (efflorescence) on masonry.
- Bulging, leaning or cracking.
- Water pooling behind or above the wall after rain.
- Weep holes that are blocked.
If you see these, clear outlets and weep holes and check where roof or surface water is going. For a full overview of planning a wall, see the DIY retaining wall guide.