Retaining Walls

What is the 1/3 rule for retaining walls?

The 1/3 rule for retaining walls usually means burying a third of the wall height, but it has other meanings too. Here is what each means and its limits.

On this page
  1. Short answer
  2. Meaning 1: embedment depth
  3. Meaning 2: the middle-third rule
  4. Meaning 3: batter or setback
  5. Does the rule apply to every wall?
  6. Other rules that matter more

Short answer

The “1/3 rule” for retaining walls most often refers to embedment: burying roughly one third of the wall’s total height below ground. A wall that is 6 feet tall in total would have about 2 feet below grade. But the phrase is used for other ideas too, and not everyone means the same thing, so check which rule a source is talking about before you apply it.

Meaning 1: embedment depth

The common version says to bury about one third of the total wall height. The purpose is to resist sliding and tipping, and to put the base below the zone where frost and surface erosion can weaken the support in front of the wall. Some guides give a range, such as one third to one half of the exposed height, depending on soil and load.

Be careful with this one, though:

  • Different wall types use different rules. Many manufacturers of segmental retaining wall blocks specify a much smaller embedment, often a minimum such as the first course or about 6 inches, plus a small additional amount per foot of wall height. Their instructions are tested for their own systems and should take priority.
  • For cantilever and poured concrete walls, the footing is designed, and the depth is mainly set by frost depth and soil bearing, not a fixed ratio.
  • Whether the rule means one third of the total height or of the exposed height differs between sources, which can change the answer significantly.

For small walls, see whether a 2 foot retaining wall needs a footing.

Meaning 2: the middle-third rule

In structural design, the “middle third” rule says the resultant force on a wall’s base, combining the weight of the wall and the push of the soil, should fall within the middle third of the base width. When it does, the base stays in compression across its full width and the wall is less likely to overturn. This is an engineering check on gravity and masonry walls, and brickwork design guidance refers to it. It is not something you apply with a tape measure; it comes out of the design calculation.

Meaning 3: batter or setback

Some people use one-third (or a similar ratio) for how far the wall leans back into the slope, called batter. Leaning the wall into the soil helps it resist the load. Segmental blocks build this in with a setback per course. Dry stone and gabion walls also lean back; see dry stone walls and gabion walls. The typical ratios are much steeper than 1:3, so treat any “1/3” batter claim sceptically and use the system’s own figures.

Does the rule apply to every wall?

No. Rules of thumb are a starting point for planning, not a design. Walls that are tall, on poor soil, beside a slope, driveway or building, or where water is a problem are better handled by an engineer. Walls above a certain height often need approval anyway; see permits and planning permission.

Other rules that matter more

For a complete planning workflow, see the DIY retaining wall guide.

The complete guide to retaining walls

How to Build a Retaining Wall Yourself: Materials and Planning
Read the guide

Keep exploring

Guides from other topics

All topics →