Bricklaying and Mortar

Do you use sharp sand or building sand for mortar?

Building sand (soft sand) is normally used for bricklaying mortar, while sharp sand suits concrete. Here is why, and when the two get mixed.

On this page
  1. The short answer
  2. How the two sands differ
  3. Why building sand suits mortar
  4. Can you use sharp sand in mortar at all?
  5. Where sharp sand is the right choice
  6. Sand quality tips
  7. In the US

The short answer

For bricklaying and blockwork mortar, use building sand, also called soft sand or, in the US, masonry sand. Sharp sand is coarser and is normally used for concrete, screeds and some paving work, not for brick mortar.

How the two sands differ

Building (soft) sand Sharp sand
Grain size Finer, more rounded and mixed in size Coarser, more angular
Feel in a mix Smooth, creamy and sticky Gritty and harsh
Typical use Bricklaying mortar, pointing, rendering Concrete, screeds, bedding some paving

Exact products vary by region and supplier, so check what your merchant calls each one.

Why building sand suits mortar

  • Workability: Mortar has to spread easily, fill the bed and perpend joints, and hold its shape on the trowel. Fine sand gives a smooth, buttery mix that does this well.
  • Bond and joint finish: A smooth mortar fills the surface texture of the brick and leaves a neat joint when tooled.
  • Thin joints: Brick joints are usually only about 10 mm thick (see how thick mortar joints should be). Coarse particles make thin joints harder to lay.

Mortar made with sharp sand can be harsh, hard to trowel and prone to being stiff for the bricklayer, which is one reason beginners find it difficult.

Can you use sharp sand in mortar at all?

Some builders do use sharp sand in certain mixes, for example a stronger mix for a footing or a foundation course, or blend a little with soft sand to change the mix. A forum thread of novice questions turns up claims ranging from soft sand with lime and plasticiser to a plain cement and sharp sand mix, so you will see conflicting advice. In general, if you want a mortar that is easy to lay and give consistent results, soft sand is the safer choice. If you have a special requirement, check with your supplier or the specification.

Where sharp sand is the right choice

Our article on mortar mix ratios lists typical cement-to-sand proportions for brick and block mortar.

Sand quality tips

  • Choose clean, washed sand. Silt, clay, salt or organic matter weaken mortar and can cause staining.
  • Keep sand covered and dry or at least a consistent dampness. Wet sand bulks up, so a “bucket of sand” contains less actual sand and the ratio changes. See how to judge mortar consistency.
  • Use sand from the same batch for a visible wall. Different sands change the mortar colour.

In the US

The names differ. In the US the equivalent of building sand for mortar is generally masonry sand (fine, clean sand). Sand sold as “concrete sand” or “sharp” or “coarse” sand is meant for concrete. If you are using bagged mortar mix, the sand is already included.

The complete guide to bricklaying and mortar

Mortar Mix Ratios for Bricks and Blocks
Read the guide

Keep exploring

Guides from other topics

All topics →