Patios and Paving

How Deep Should the Sub-Base Be for a Patio?

How deep should the sub-base be for a patio? Typical depths for slabs and pavers, total excavation examples, when to go deeper, and how to compact it.

On this page
  1. Short answer
  2. Layers and total dig depth
  3. When to go deeper
  4. Sub-base material
  5. Compaction
  6. Geotextile
  7. Mistakes

Short answer

For a typical garden patio used by people and furniture, a compacted sub-base of roughly 100 to 150 mm (4 to 6 inches) is a common recommendation. Go towards the deeper end, or beyond it, on soft or clay soil, in areas with hard frosts, or if the paving may carry vehicles. Driveways generally need substantially more than patios. Always check any guidance from your paving supplier and your local conditions.

Layers and total dig depth

The sub-base is only one layer. Work out the total excavation by adding up what goes on top:

Example: slabs on a mortar bed

  • Sub-base: about 100 mm
  • Mortar bed: about 30 to 40 mm
  • Slab: say 20 to 40 mm
  • Total: roughly 150 to 180 mm below the finished surface

Example: interlocking pavers

  • Sub-base: about 100 to 150 mm
  • Bedding sand: about 25 mm
  • Paver: about 60 mm
  • Total: roughly 185 to 235 mm

Your surface should also finish at the right height relative to the house, doors and any damp-proof course. See laying paving slabs on an existing concrete base for how added height can create problems, and remember the finished surface needs a fall. See what slope a patio should have for drainage.

When to go deeper

  • Soft, clay or peaty ground, which holds water and moves.
  • Cold climates with freeze-thaw cycles, where a thicker free-draining base helps reduce frost problems.
  • Heavier use, such as a hot tub, a shed, vehicles or a driveway.
  • Poorly draining sites, where a deeper base improves drainage.

If you are not sure, a deeper base is usually cheap insurance compared with relaying a patio.

Sub-base material

In the UK this is typically crushed stone such as MOT Type 1. In the US it is crushed stone or crusher-run base, often around 3/4 inch minus. These materials contain a mix of sizes that lock together when compacted. Rounded gravel does not compact as well, and soil or builders’ rubble containing organic or soft material is best avoided.

Compaction

Compact the base in layers rather than one thick lift. A commonly given limit is around 100 mm (4 inches) at a time with a plate compactor. Dampen dry material slightly, and make several passes in different directions. Uncompacted base is a leading cause of sinking later. See common mistakes to avoid when laying pavers.

Geotextile

On soft or clay soil, a geotextile membrane under the base helps stop the stone sinking into the ground and keeps the layers separate. It is also used to limit weeds growing from below.

Mistakes

  • Digging too shallow, then trying to make up the level with a thick sand or mortar bed.
  • Skipping compaction, or compacting only the final layer.
  • Not allowing for the fall when marking out depths.

Once the base is in, the next step is the layer on top. For slabs, see our mortar mix guide. For small units, see interlocking concrete pavers.

The complete guide to patios and paving

Best Mortar Mix for Laying Patio Slabs
Read the guide

Keep exploring

Guides from other topics

All topics →