Patios and Paving

Can You Lay Patio Slabs on Sand, or Do You Need a Mortar Bed?

Can you lay patio slabs on sand, or do you need a mortar bed? When sand works, when mortar is better, and what to do for porcelain and large slabs.

On this page
  1. Short answer
  2. When sand works
  3. When to use a mortar bed
  4. Why sand alone struggles under large slabs
  5. Sand versus sand and cement
  6. Porcelain and thin slabs
  7. Pros and cons
  8. Decision guide

Short answer

You can lay some paving on sand, but it depends on the type of paving and how it will be used. Small interlocking pavers are designed to go on a thin bed of sand. Large patio slabs are more commonly laid on a full mortar bed, because sand alone does not hold them firmly. Porcelain slabs usually need a mortar bed or other specified system. If you are unsure, a mortar bed is the more forgiving, more commonly recommended choice for slabs.

When sand works

  • Interlocking pavers. These are laid on about 25 mm (1 inch) of screeded sand over a compacted base, with sand in the joints and an edge restraint. The system relies on the units being small and interlocked. See interlocking concrete pavers.
  • Light-use garden paths and stepping stones, where occasional movement is acceptable and easy relaying is a benefit.
  • Temporary or easy-to-adjust areas.

Sand beds drain well and are quick to lay, and slabs are easy to lift and relay.

When to use a mortar bed

  • Large concrete flags or natural stone slabs on a patio.
  • Areas with furniture, barbecues or regular heavy foot traffic.
  • Porcelain slabs, where manufacturers usually specify a full mortar bed with a slurry primer.
  • Anywhere the slabs sit on an existing concrete base. See laying paving slabs on an existing concrete base.

A full bed supports the slab across its whole back, reducing rocking, cracking and voids. Our mortar mix guide for patio slabs covers ratios and mixing.

Why sand alone struggles under large slabs

A large flat slab rests on a thin sand bed that can shift. Rain, foot traffic and ants can wash out or disturb sand under the edges, leaving high and low corners that rock. Corners and edges then carry load unevenly and can crack. Sand also gives no bond to the slab, so slabs can drift apart.

Sand versus sand and cement

You can mix sharp sand and cement, and that is what most bedding mortar is. Damp, semi-dry sand and cement is stronger and more stable than sand alone, but it sets, so slabs are harder to adjust after a short working time. A genuinely dry sand and cement mix relies on moisture reaching it later and is less reliable. For details, see the mortar mix guide.

Porcelain and thin slabs

Porcelain is dense, thin (often about 20 mm outdoors) and non-porous, and needs full support and a good bond. Follow the manufacturer’s laying instructions. Some systems allow other methods, such as pedestals or gravel beds, but those are specific systems, not just slabs on sand.

Pros and cons

Sand bed Mortar bed
Speed Faster Slower, with a limited working time
Adjustment Easy to lift and relay Hard once set
Stability under big slabs Weaker Stronger
Drainage Better Water runs off the surface or through joints
Skill needed Lower Higher

Decision guide

  • Small interlocking pavers: sand bed, with proper edge restraint.
  • Large slabs, stone or porcelain on a patio: mortar bed.
  • Light garden path with modest slabs: sand can work, but mortar is more durable.

Whichever you choose, the base matters more than the bedding. See how deep the sub-base should be for a patio and common mistakes to avoid when laying pavers.

The complete guide to patios and paving

Best Mortar Mix for Laying Patio Slabs
Read the guide

Keep exploring

Guides from other topics

All topics →