Patios and Paving

What are common mistakes to avoid when laying pavers?

Common mistakes to avoid when laying pavers and slabs: weak bases, poor drainage, wrong sand, wet mortar, missing edge restraint and rushed jointing.

On this page
  1. Short answer
  2. Base mistakes
  3. Drainage mistakes
  4. Bedding layer mistakes
  5. Laying mistakes
  6. Edge and joint mistakes
  7. Planning mistakes
  8. Quick checklist

Short answer

The most common mistakes are an inadequate or poorly compacted base, no drainage fall, the wrong sand or a bad mortar mix, no edge restraint, and rushing the jointing. Most problems that show up later, such as sinking, rocking, weeds and standing water, trace back to what was done (or skipped) below the surface.

Base mistakes

  • Laying straight onto soil. Without a compacted base, paving tends to shift, sink and heave. Do not lay directly on dirt.
  • Too thin a base. Many guides suggest around 100 to 150 mm (4 to 6 inches) of compacted stone for patios and paths, with more for driveways or soft ground. See how deep the sub-base should be for a patio.
  • Not compacting in layers. Thick layers compact unevenly. Add the base in stages and compact each with a plate compactor.
  • Skipping geotextile on soft, clay or poorly draining soil, where the base can mix into the ground below.

Drainage mistakes

  • No fall. Flat paving holds water, which can lead to slippery algae, frost damage and water running towards the house. See what slope a patio should have for drainage.
  • Surface too high against the house. Paving that sits close to or above the damp-proof course, or door thresholds, can cause damp problems.

Bedding layer mistakes

  • Wrong sand. Fine, soft sand is generally not a good setting layer under pavers or slabs. Coarser, angular sand compacts and drains better.
  • Bedding layer too thick. For interlocking pavers it is usually only about 25 mm (1 inch). Do not use it to fill low spots in the base.
  • Mortar too wet or too weak. A soupy mix shrinks and leaves voids. See our mortar mix guide for patio slabs.
  • Spot bedding large slabs. Spots of mortar leave voids that can cause rocking and cracking. A full bed is usually better practice.
  • Choosing the wrong method for the slab. Some slabs, such as porcelain, usually need a full mortar bed and a primer. See can you lay patio slabs on sand.

Laying mistakes

  • Not working from a string line, so rows drift and joints wander.
  • Not mixing pallets, which can leave visible colour bands in the finished surface.
  • Walking on screeded sand and leaving footprints that print through.
  • Rushed cutting. Measure, mark and cut carefully, using a saw with dust control and protective equipment.
  • Walking or driving on slabs too soon before the mortar has set.

Edge and joint mistakes

Planning mistakes

  • Choosing a paver too thin for the load. Pedestrian paving is not suited to vehicles.
  • Ordering too little. Order extra for cuts and breakages, commonly around 5 to 10 percent.
  • Underestimating the cost of the base compared with the surface material.

Quick checklist

  1. Compacted base, in layers, of suitable depth.
  2. Fall away from the house, with surface height checked against the DPC.
  3. Correct bedding material and thickness.
  4. String lines and consistent joints.
  5. Edge restraint or mortar haunching.
  6. Joints filled with a material that suits the bed.

The complete guide to patios and paving

Best Mortar Mix for Laying Patio Slabs
Read the guide

Keep exploring

Guides from other topics

All topics →