Concrete Slabs

Is 4 inches of concrete enough for a shed base?

Is a 4-inch (100 mm) concrete slab enough for a garden shed? Learn when it works, when to go thicker, and why the base underneath matters just as much.

On this page
  1. Short answer
  2. When 4 inches is enough
  3. When to go thicker
  4. The base underneath matters
  5. Size, level and edges
  6. Mix, reinforcement and curing

Short answer

For a typical domestic garden shed, a slab of about 4 inches (100 mm) on a properly compacted base is generally considered adequate. It is the thickness most DIY guides use for sheds and similar light buildings. For heavier buildings, workshops with machinery, or any base that may carry a vehicle, many people go thicker, around 150 mm (6 in), and add reinforcement. If the structure is large or heavy, ask a structural engineer or the building supplier.

When 4 inches is enough

A 100 mm slab commonly suits:

  • A standard timber or metal garden shed used for storage.
  • Small summerhouses and lightweight outbuildings.
  • Bases poured on firm, well-drained ground over a compacted sub-base.

A shed’s weight is low and spread across the base, so the slab is mainly there to provide a flat, level, stable surface, not to carry a heavy structural load.

When to go thicker

Consider 150 mm (6 in) or an engineered design if:

  • The building is a heavy workshop, or holds machines, a workbench with heavy tools or a vehicle.
  • The ground is soft, clay, or otherwise variable.
  • The base will have walls built on it (for example, a masonry building), where the load is concentrated along the edges. In that case, thickened edges or foundations are normally used; for brick walls, see how deep a footing should be for a brick wall.
  • You are in an area with notable frost or drainage problems.

Thicker concrete will not make up for an unprepared base. If the soil is poor, improve the base rather than just adding depth.

The base underneath matters

Most shed-base problems come from the ground, not the slab thickness. Strip the topsoil and soft material, and lay a compacted layer of crushed stone or hardcore, often around 100 mm (4 in) deep, before pouring. See how much gravel you need under a concrete slab and whether you can pour concrete over dirt.

Size, level and edges

  • Make the slab slightly larger than the shed’s footprint, or at least equal to it, so the walls and floor frame are well supported. Many suppliers recommend a size and say whether the base should be smaller than the shed floor so water doesn’t pool beneath; check the instructions for yours.
  • Keep it level, or with a very slight fall for drainage if the supplier allows it.
  • Form the edges neatly so the shed bearers sit evenly.

Mix, reinforcement and curing

A general-purpose mix, often around 1 : 2 : 4 (cement : sand : coarse aggregate) by volume, or a bagged mix, is typical. For a small base, steel mesh can help control cracking, though many light sheds do without. See rebar or wire mesh in a concrete slab for guidance. Whatever mix you use, keep the new slab damp or covered for several days; our curing concrete guide explains how. For the full process, see how to lay a concrete slab.

The complete guide to concrete slabs

How to Lay a Concrete Slab: Base, Mix and Pouring in Sections
Read the guide

Keep exploring

Guides from other topics

All topics →