Short answer
It is best to avoid it. A light drizzle may be manageable if you are prepared and protect the surface, but moderate or heavy rain can damage fresh concrete, and when rain is forecast, postponing the pour is usually the safer choice. Ready-mix suppliers and builders generally prefer to reschedule when significant rain is expected. A slab is hard to fix once it is spoiled, and a day’s delay is cheap by comparison.
Why rain is a problem
- Extra water in the surface. Rain falling on fresh concrete mixes with the top layer and raises its water content there, which can leave a weak, dusty or scaling surface.
- Washed-out cement. Heavy rain can wash cement paste from the surface and leave aggregate exposed, or pit it.
- Surface marks. Raindrops and runoff leave craters and streaks that can’t easily be finished away.
- Waterlogged base and formwork. Standing water in the forms or on the base can dilute the mix at the bottom of the pour and soften the ground.
- Delayed setting, and complications for finishing times and joint cutting.
Rain falling after the concrete has hardened enough is much less of a worry, which is why timing and cover matter.
Before the pour
- Check a reliable forecast for the whole pour and finishing window, not just the start.
- Have large plastic sheets or tarpaulins and supports ready, so cover can be placed quickly. Raise the cover on battens, so it doesn’t touch the surface.
- Keep forms and base free of standing water, and plan drainage away from the slab.
- Keep cement and aggregates under cover so they don’t become soaked, as wet sand changes the water content of the mix.
- If you are ordering ready-mix, tell the supplier about the forecast and ask about rescheduling.
If it starts raining mid-pour
- Stop adding water to the mix. Don’t compensate for wet materials by adding extra, and reduce water if the aggregates are wet.
- Cover the placed concrete quickly with plastic sheeting or tarpaulins, supported so they clear the surface.
- Don’t finish through the rain. Don’t float or trowel water into the surface. Leave the surface alone until the rain stops.
- Don’t brush or spray the water off while it is soft. If surface puddles form, leave them for the moment, then remove them carefully once the surface can bear it, for example by dragging a hose or squeegee lightly, without working them back in.
- Decide whether to continue. If the rain is heavy, finish the section you are on, make a tidy construction joint if sections are planned, and stop. See pouring a slab in sections.
After the pour
Once finished, keep the slab covered through any rain for the first day or so. Rain after the surface has begun to harden is far less harmful, though a freshly floated surface can still be marked. Covering also helps with moisture retention, so keep up with proper curing. Cold, wet weather adds the risk of frost, so insulate if the temperature may fall close to freezing.
Signs of damage and what to do
- Dusty, crumbly or scaled surface, or exposed aggregate where cement washed away.
- Pitting and craters from heavy drops.
- Soft or weak patches that scratch easily after the slab should have hardened.
Minor surface damage can sometimes be dealt with later by grinding, sealing or a thin repair coat, depending on the damage. Widespread weakness may need an overlay or replacement; see pouring concrete over an existing slab. If in doubt, ask a concrete professional to assess it.
When to postpone
- Heavy or prolonged rain is forecast during the pour or the following hours.
- Temperatures are close to freezing or forecast to be.
- You can’t cover the whole slab quickly.
- The base is waterlogged and can’t be drained.
A short delay is almost always better than a damaged slab. For paving and driveways where surface quality matters, as covered in concrete mixes for driveways, paths and pervious paving, it’s even more worthwhile to wait for a dry spell.